F 150 2WD V8-4.6L VIN 8 (2009)
4. Connect the large RCM electrical connector.
-
Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
-
Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
5. Connect the small RCM electrical connector and push the lock tab in.
6. If equipped, install the floor console.
7. If equipped, install the front center seat cushion and cupholder assembly.
8. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair.
9. If a new RCM was installed, carry out the appropriate steps to complete the Programmable Module Installation (PMI) procedure. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning