F 150 2WD V8-4.6L VIN 8 (2009)
Remove the selector lever cable end from the manual control lever.
5. Disconnect the Transmission Range (TR) sensor connector.
6. NOTE: Discard the manual control lever shaft outer nut. Do not reuse. The old nut will not retain the proper torque specification.
Remove the manual control lever.
1. Remove and discard the manual control lever outer nut.
2. Remove the manual control lever.
7. Remove the TR sensor bolts and the TR sensor.
8. Loosen, but do not remove the transmission fluid pan bolts and allow the transmission fluid to drain. Once the transmission fluid has drained,
remove the bolts. Remove the transmission fluid pan and gasket.
9. Clean and inspect the transmission fluid pan, transmission fluid pan gasket and the magnet.
