F 150 2WD V8-4.6L VIN 8 (2009)
6. Remove the U-washer.
1. Push in on the axle shaft.
2. Remove the U-washer.
7. Remove the axle shaft.
Installation
1. Lubricate the lip of the axle shaft oil seal with grease.
2. Install the axle shaft.
3. NOTE: Do not damage the rubber O-rings in the U-washer grooves.
Install the U-washer.
1. Position the U-washer on the button end of the axle shaft.
2. Pull the axle shaft outward.
4. NOTE: If a new differential pinion shaft lock bolt is unavailable, coat the threads of the original differential pinion shaft lock bolt with threadlock