F 150 2WD V8-5.4L Flex Fuel (2008)
![background image](/ford/f_150_2wd/v8-5.4l_flex_fuel/Page-1398001.png)
Seals and Gaskets: Service and Repair
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Removal
CAUTION: Use care not to damage the manual control lever shaft bore. The new seal can leak.
CAUTION: Discard the outer manual control lever shaft nut. Do not reuse. The old nut will not retain the torque specification.
NOTE: When removing the manual control lever shaft retaining pin, use a soft cloth to protect the surface of the case.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
Four wheel drive (4WD) vehicles
2. Remove the front driveshaft shield nuts and remove the shield.
3. NOTE: Index-mark the front and rear flange.
NOTE: It is not necessary to remove the front driveshaft from the vehicle.
Index-mark the front and rear flange, disconnect the front driveshaft and position aside.