F 150 2WD V8-5.4L Flex Fuel (2008)
3. Index-mark the driveshaft to the extension housing to maintain alignment during installation.
4. Remove and discard the 4 driveshaft flange bolts.
^
To install, tighten the 4 new bolts to 103 Nm (76 lb-ft).
5. CAUTION: The driveshaft flange fits tightly on the flange pilot. Never hammer on the driveshaft or any of its components to disconnect
the driveshaft flange from the flange pilot. Pry only in the area shown with a suitable tool to disconnect the driveshaft flange from the
flange pilot or damage to the driveshaft flange can occur.
Using a suitable tool as shown, disconnect the driveshaft flange from the flange pilot and remove the driveshaft.