F 150 2WD Pickup V8-4.6L (2002)
Wheel Speed Sensor: Service and Repair
Rear Antilock Control
Sensor - Rear
Removal and Installation
1. Raise and support vehicle.
2. NOTE: Clean off dirt and debris that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake sensor.
1
Disconnect the rear anti-lock brake sensor electrical connector.
2
Remove the bolt.
3
Remove the rear anti-lock brake sensor.
3. NOTE: Thoroughly clean the mounting surface.
NOTE: Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the O-ring with SAE-75W-140 high Performance Rear Axle
Lubricant FlT7,19580-B or equivalent meeting Ford specification WSL-M2C192-A.
To install, reverse the removal procedure.