F 150 2WD Pickup V8-4.6L (2002)
5.
Screen shows progress bar, then screens tells you WDS cannot communicate with the PCM and gives you a "YES" selection and a "NO" selection;
select "NO".
6.
Make sure the key is still OFF. Press TICK.
7.
Screen then shows turn ignition ON, Now turn ignition to ON.
8.
Screen shows "The PCM installed to this vehicle is blank". You will be prompted with a list of previous sessions to check if the vehicle was
previously identified; press TICK.
9.
Select "None of the above".
10.
Screen shows "To enable WDS to reprogram the PCM with the correct calibration"; please enter the vehicle calibration number (7 digits) or the
tear tag number (4 digits), press TICK.
NOTE
PCM ENGINEERING NUMBER, CALIBRATION NUMBER AND TEAR TAG NUMBER ARE FOUND ON THE PCM PLASTIC
ELECTRICAL CONNECTOR (I.E PCM ENGINEERING NUMBER 1L5F-12A650-MB, TEAR TAG NUMBER RIH1). THE TEAR TAG
NUMBER MAY ALSO BE FOUND ON A SQUARE WHITE TAG WITH BLACK LETTERS LOCATED ON THE RIGHT FRONT FENDER
AREA NEAR WHERE THE FENDER MEETS THE COWL.
11.
Input the PCM engineering number, enter the first (4) digits then select the box at the end of the part number and enter the last (2 or 3) digits of the
part number; press TICK.
12.
Screen shows "Set ignition switch to OFF", turn ignition OFF; press TICK.
13.
Screen shows "Remove fuel pump relay and cooling fan relays to prevent electrical interference and battery drain". Press TICK
14.
Screen shows "Is vehicle equipped with PATS:
Yes or No?" Select correct answer, the screen shows "Please wait" and progress bar moving at bottom of screen.
15.
Screen shows "Set ignition switch to ON" - turn ignition to ON. Screen then shows "Downloading data" with a progress bar.
16.
Screen shows "Set Ignition switch to OFF", turn ignition OFF then press TICK.
17.
Screen shows "This module requires some configuration settings"; manually select those parameters for your vehicle; press TICK.
18.
Screen shows "Set Ignition to ON", turn ignition to ON; press TICK.
19.
Screen shows selection of parameters:
^
4X4 low range input - (PCM)? = Yes or No?
^
Manual shift on the fly - (PCM)? = manual or not manual?
^
Tire size? = Selection of tire sizes
^
Axle Ratio? = Selection of axle ratios
Choose the correct information for your vehicle; press TICK.
NOTE
EVEN THOUGH THE PARAMETER APPEARS CORRECTLY PROGRAMMED ON THE WDS SCREEN, YOU MUST MANUALLY
RE-SELECT EACH ONE WITH THE CORRECT SELECTION OR WDS WILL NOT CORRECTLY PROGRAM THESE PARAMETERS.
20.
Screen shows "Set ignition switch to OFF", turn ignition OFF; press TICK.
21.
Screen shows "Set ignition switch to ON"; turn ignition ON.
22.
Screen shows "Downloading data", then "Calibration has been loaded and checked"; press Tick.
23.
Screen shows "Set ignition switch to OFF", turn ignition to OFF; press TICK.
24.
Screen shows "Reinstall Fuel pump relay and cooling fan relays" - Reinstall fuel pump relay; press Tick.
