F 150 2WD Pickup V8-4.6L (2002)
4
Press the bearing cup to just below the snap ring groove.
-
Repeat to install the new bearing cup on the opposite side of the driveshaft centering socket yoke.
6. Install the driveshaft centering socket yoke and new bearing cups.
1
Start a new bearing cup in the driveshaft center yoke.
2
Position the spider in the driveshaft center yoke.
3
Position the assembly in the special tool.
4
Press the bearing cup to just below the snap ring groove.
5
Repeat to install the new bearing cup on the opposite side of the driveshaft center yoke.
7. Install the remaining new snap rings.
8. CAUTION: Do not strike the bearings.
Check the U-joints for freedom of movement. If bearings are binding, strike the yoke with a plastic hammer.