F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
NOTE:
The crankshaft pulley must be installed within four (4) minutes after applying silicone. Apply Silicone Gasket and Sealant F6AZ-1 9562-AA or
equivalent, to woodruff key slot on crankshaft pulley. See Figure 65.
^ Using Crankshaft Damper Replacer T74P-6316-B, install crankshaft pulley.
^
Loosely install crankshaft pulley bolt.
^
Tighten crankshaft pulley bolt to 90 Nm (66 lb-ft).
^
Loosen crankshaft pulley bolt one (1) full turn.
^
Tighten crankshaft pulley bolt to 47-53 Nm (34-39 lb-ft).
^
Tighten crankshaft pulley bolt an additional 85-90 degrees (1/4 turn).
46.
On Romeo engines, proceed as follows:
^
Position power steering pump in installed position. Tighten two (2) upper bolts to 20-30 Nm (15-22 lb-ft).
^
Raise vehicle.
^
Install two (2) power steering pump lower retaining bolts. Tighten bolt to 20-30 Nm (15-22 lb-ft).
47.
On 4.6L and 5.4L Windsor engines, proceed as follows:
^
Position power steering pump in installed position. Tighten two (2) upper bolts to 20-30 Nm (15-22 lb-ft).
^
Raise vehicle.
^
Install power steering pump lower retaining bolt. Tighten bolt to 20-30 Nm (15-22 lb-ft).