F 150 2WD Pickup V8-4.6L SOHC VIN W (1998)
19. Disconnect the oil pressure sending unit electrical connector.
20. Lower the vehicle.
21. Remove the fuel charging wiring.
INSTALLATION
WARNING:
-
DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY
FUEL RELATED COMPONENTS. HIGHLY FLAMMABLE MIXTURES ARE ALWAYS PRESENT AND MAY BE IGNITED
RESULTING IN POSSIBLE PERSONAL INJURY.
-
FUEL IN THE FUEL SYSTEM REMAINS UNDER HIGH PRESSURE EVEN WHEN THE ENGINE IS NOT RUNNING.
1. Position the fuel charging wiring on the engine.
2. Raise the vehicle on a hoist.
3. Connect the oil pressure sending unit electrical connector.
4. Connect the crankshaft position sensor electrical connector.