F 150 2WD Pickup V8-4.6L SOHC VIN W (1998)
Valve Body: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Drain transmission fluid and remove the transmission fluid pan and filter.
4. Disconnect the molded lead frame from the sensors.
1
Disconnect the shift solenoid SSA/SS1 and SSB/SS2.
2
Disconnect the Torque Converter Clutch (TCC).
3
Disconnect the Electronic Pressure Control (EPC) solenoid.
4
Disconnect the bulkhead inter-connector.
CAUTION: Do not pull on the plastic lead frame. This may cause damage to the connector ends. Carefully pry up on locking tabs to
disconnect the sensors.
5. Remove the shift solenoid and the TCC solenoid.
1
Remove the bolts.
2
Remove the shift solenoid and the TCC solenoid.
