F 150 2WD Pickup V8-4.6L SOHC VIN W (1998)
![background image](/ford/f_150_2wd_pickup/v8-4.6l_sohc_vin_w/Page-1534007.png)
6. Rotate the Gauge Block several half-turns to ensure proper seating of the pinion bearings, and position the Gauge Block.
NOTE: The Gauge Block must be offset to obtain an accurate reading.
7. Install the Gauge Tube.
1
Position the Gauge Tube.
2
Install the differential side bearing caps.
3
Install the differential side bearing cap bolts.
8. Use a drive pinion bearing adjustment shim as a gauge for shim selection.
^
After the proper shim thickness has been determined, remove the Gauge Tube.
NOTE: Drive pinion bearing adjustment shims must be flat and clean. A slight drag should be felt for correct shim selection. Do not attempt
to force the pinion shim between the Gauge Block and the Gauge Tube. This will minimize selection of a pinion shim thicker than required,
which results in a deep tooth contact in the final assembly of integral rear axle assemblies.
9. Use a press and the Pinion Bearing Cone Replacer to press the pinion bearing until it is firmly seated on the pinion and pinion shim.