F 150 2WD Pickup V8-4.6L SOHC VIN W (1998)
6. Remove the driveshaft flange yoke.
1
Position the driveshaft flange yoke in the U-Joint Tool.
2
Press out a bearing cup.
3
Remove the driveshaft flange yoke.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft flange yoke.
7. Remove the spider.
1
Reposition the driveshaft in the U-Joint Tool.
2
Press out the bearing cup.
3
Rotate the driveshaft.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the spider.
8. Clean the yoke area at the end of the driveshaft.
ASSEMBLY
1. Install the spider.
1
Start a new bearing cup into the driveshaft yoke.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup below the yoke surface.
^
Repeat for the other bearing cup.