F 150 2WD Pickup V8-4.6L VIN W (2006)
3. Install the special tools on the camshaft being serviced.
4. Install the camshaft sprocket spacer, camshaft sprocket, washer and bolt onto the camshaft being serviced. Tighten the camshaft sprocket bolt in 2
stages:
^
Stage 1: Tighten to 40 Nm (30 ft. lbs.).
^
Stage 2: Tighten an additional 90 degrees.
5. Install the special tool between the valve spring coils to protect the valve stem seal from damage.
6. NOTE: The camshaft roller followers must be installed in their original locations.
NOTE: The 3 rearmost camshaft roller followers on the RH side must use special tool 303-567 in the same manner as is shown in the illustration.
NOTE: Lubricate the camshaft roller follower with clean engine oil prior to installation.
Using the special tool, compress the valve spring and install the camshaft roller follower.
^
Install all of the camshaft roller followers onto the camshaft being serviced.
7. Install the timing drive components.
