F 150 2WD Pickup V8-4.6L VIN W (2006)
Clean the mating surfaces of the cylinder head and the intake manifold with metal surface prep and silicone gasket remover. Follow the directions
on the packaging.
2. Install the intake manifold.
1. Position the new intake manifold gaskets.
2. Position the intake manifold.
3. Loosely install the 9 intake manifold bolts.
3. Tighten the intake manifold bolts in the sequence shown.
^
Tighten to 10 Nm (89 inch lbs.).
4. Attach the wiring harness to the left valve cover.
5. Install the thermostat.
6. Install the thermostat housing and a new thermostat housing O-ring seal.
7. Install the 2 thermostat housing bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
8. Connect the electronic throttle control electrical connector.
9. Install the 8 ignition coil and the 8 ignition coils bolts.
^
Tighten to 6 Nm (53 inch lbs.).
