F 150 2WD Pickup V8-4.6L VIN W (2006)
Steering Wheel: Service and Repair
Steering Wheel
Steering Wheel
Special Tool
Removal and Installation
CAUTION: Removing the steering wheel without using a puller can damage the column bearings.
NOTE: Due to manufacturing differences, the original steering wheel locating splines may not match a replacement steering wheel. If the steering
wheel is not centered after a new steering wheel has been installed, a front toe adjustment will be required.
1. Place the steering wheel in the straight-ahead position and turn the ignition switch to the OFF position.
2. Remove the driver air bag module.
3. Disconnect the steering wheel switches electrical connector.
4. NOTE: Do not remove the bolt until the steering wheel has been separated from the column.
Loosen the steering wheel bolt.
5. Using the special tool, separate the steering wheel from the steering column assembly.
6. Remove the steering wheel bolt and the steering wheel.
^
To install, tighten to 40 Nm (30 ft. lbs.).
7. To install, reverse the removal procedure.
