F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
2. NOTE: Prior to installation, lightly lubricate the gerotor gears with clean Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid
XT-2-QDX or equivalent Meeting MERCON specification.
Install the (A) gerotor gearset, with the (B) dot facing the control body assembly. MERCON(R) automatic Transmission Fluid is being replaced by
MERCON(R) V as a service fluid, as per TSB 06-14-4.
3. CAUTION: Prior to pump assembly, make sure all cup plugs are installed.
CAUTION: Inspect mating surfaces of the pump body and the control body to make sure they are clean and free of nicks and burrs.
Lower the (A) control body and stator assembly onto the (B) pump body, aligning the (C) 28 mm hole in each body.
4. NOTE: Make sure that the outer edges of the pump body and the outer bolt holes are aligned during assembly.
Using the special tool, assemble the pump and loosely install 11 bolts.
1
Install the 10mm alignment bolt.
2
Tighten the bolts.
