F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
NOTE:
TA-1 adhesive has a working time of about 40-50 minutes at 21°C (70° F).
^
For about every 10°C (20°F) ABOVE 21°C (70°F), the working and cure time is cut in half.
^
For about every 10°C (20°F) BELOW 21°C (70° F), the working and cure time are doubled.
3.
Perform a weld bond test as follows:
1.
Prepare two (2) pieces of scrap metal as described above.
2.
Recheck the welder to be sure it is set up according to the manufacturer's recommended settings for weld bonding.
3.
Apply a 1/4-inch to 3/8-inch bead of adhesive onto the scrap metal.
4.
NOTE: Clamps should have tape over the ends to insulate them during welding.
5.
Clamp the pieces together and apply one (1) weld.
6.
Remove the clamp, then place the welded pieces in a vise and perform a destructive weld test by peeling the scrap metal apart using large
channel lock pliers.
7.
Measure the size of the nugget to determine if the nugget meets Ford Weld Nugget Requirements. See the chart below. Once a proper size
nugget is achieved, proceed with Panel Installation.
WELD NUGGET CHART
OUTER PANEL INSTALLATION AND RESISTANCE WELDING
1.
Wipe the new quarter panel of all dust and grit, preparing it for adhesive application. See Figure 18.
