F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
6.
Mix and apply the clearcoat material per manufacturer's instructions.
7.
Bake following product guidelines.
8.
Apply a new decal, if applicable. Proceed to Pickup Bed Installation.
Alternate Welding Procedure If STRSW Is Not Available
VEHICLE AND OUTER PANEL PREPARATION FOR MIG WELDING
1.
Straighten all flanges as necessary using a hammer and dolly. See Figure 28.
2.
Using a suitable grinder and a 3" Rollok(R) disc, carefully grind the mating surfaces of the receiving flange on the vehicle as follows:
^
Be sure to remove all e-coat, paint or galvanized coating from the mating surfaces.
^
If the metal has a pewter look, not all the galvanizing has been removed.
^
A shiny surface appearance must be left after grinding.
^
DO NOT damage the corners or thin the metal.
^
DO NOT GRIND above the mating surface area. This will help eliminate the possibility of corrosion formation after the repair is complete.
