F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
CAUTION: Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
CAUTION: When installing a new ABS module or hydraulic control unit (HCU), do not use the pump motor harness as a carrying handle. Failure to
follow these instructions may result in damage to the HCU assembly.
NOTE: The ABS module and the HCU are not repairable. If an internal problem exists in either one, a new part must be installed.
NOTE: When installing a new ABS module it must be configured (using vehicle as-built data) and calibrated. Follow the diagnostic tool directions
for the configuration and calibration procedures. For additional information.
1. Remove the HCU. For additional information, refer to Hydraulic Control Unit (HCU).
2. Remove the parts in the order indicated in the following illustration and table.
3. To install, reverse the removal procedure.
Item 1: Harness Connector Removal Note
1. CAUTION: When installing a new ABS module or HCU, do not use the pump motor harness as a carrying handle. Failure to follow these
instructions may result in damage to the HCU assembly.