F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
5. Tighten the disc brake caliper bleeder screw.
6. Repeat Steps 1 through 5 for the three remaining brake calipers, going in order from the LH rear disc brake caliper to the RH front disc brake
caliper ending with the LH front disc brake caliper.
7. If the brake pedal feels spongy, repeat the bleed procedure.
Anti-Lock Brake System Hydraulic Control Unit Bleeding
NOTE: This procedure is only required when a new hydraulic control unit is installed.
NOTE: When any part of the hydraulic system has been disconnected for repair or new installation, air may get into the system and cause spongy
brake pedal action. This requires bleeding of the hydraulic system after it has been correctly connected. The hydraulic system can be gravity bled,
manually bled or with pressure bleeding equipment.
1. Connect the diagnostic tool and follow the ABS system bleed instructions.
2. Use the gravity bleed or manual bleed procedure(s) to bleed the system. Begin at the RH rear caliper.
