F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
1. If not done already, slide the wire support keeper back to allow for clearance.
2. CAUTION:
-
Inspect the occupant classification sensor assembly, seat cushion pan and support assembly for any foreign objects before installing
the occupant classification sensor assembly to the seat cushion pan. If any foreign objects are found, remove them. Failure to do so
may result in personal injury, in the event of an air bag deployment.
-
Failure to route the seat occupant classification sensor components through the correct seat cushion support opening can cause
component failure.
-
While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.
Feed the OCS early build service kit components (hose, pressure sensor, seat wire harness electronic control unit) through the seat cushion pan.
3. Slide the wire support keeper back to its original position.
4. CAUTION:
-
Inspect the occupant classification sensor assembly, seat cushion pan and support assembly for any foreign objects before installing
the occupant classification sensor assembly to the seat cushion pan. If any foreign objects are found, remove them. Failure to do so
may result in personal injury, in the event of an air bag deployment.
-
While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.
Align the occupant classification sensor early build service kit foam pad wire to the seat cushion pan ears and install the hog rings.
5. Bend the tab back and slide the pressure sensor onto the bracket.
