ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Occupant Classification Sensor - Original Equipment|Page 2664 > < Occupant Classification Sensor - Original Equipment|Page 2662
Page 9
background image

11. CAUTION:  It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, or

an OCS service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the OCS system.

Attach the seat cushion trim cover J-clips to the seat cushion pan.
-

If equipped with seat integrated restraints (SIR), do not attach the RH rear J-clip at this time, so as to route the belt tension sensor wire harness
between the trim cover and seat cushion pan later in the procedure.

-

If equipped, do not attach the LH rear J-clip at this time so as to route the lumbar cable between the trim cover and seat cushion pan later in the
procedure.

CAUTION:
-

While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.

-

It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, or an OCS
service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the OCS system.

NOTE:  Occupant classification sensor (OCS) system components (seat cushion foam pad, bladder with pressure sensor and electronic control
unit) are calibrated to each other and are serviced as an assembly. The OCS system components are not to be installed separately. If a new
OCS system, OCS system component or seat cushion foam pad are needed, a new OCS system service kit (seat cushion foam pad, bladder with
pressure sensor and electronic control unit) must be installed as an assembly.

12. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat

removal and installation procedure.

NOTE:  Make sure the battery ground cable is still disconnected before proceeding with the installation portion of this procedure.

Install the passenger seat into the vehicle. Do not reactivate or prove out the supplemental restraint system at this time.

Occupant Classification Sensor - Original Equipment|Page 2664 > < Occupant Classification Sensor - Original Equipment|Page 2662