F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
Seals and Gaskets: Service and Repair
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Special Tools And Equipment
Special Tool(s)
Removal and Installation
CAUTION: Use care not to damage the manual control lever shaft bore. The new seal can leak.
CAUTION: Discard the outer manual control lever nut.
NOTE: When removing the manual control lever shaft retaining pin, use a soft cloth to protect the surface of the case.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. On 4x4 vehicles, remove the front driveshaft shield nuts and remove the shield.
3. NOTE: Index-mark the front and rear flange.
NOTE: It is not necessary to remove the front driveshaft from the vehicle.