F 150 4WD V8-4.6L VIN 8 (2010)
Communications Control Module: Removal and Replacement
Audio Digital Signal Processing (DSP) Module - Split Bench
Audio Digital Signal Processing (DSP) Module - Split Bench
NOTE: The seats are shown removed for clarity only.
Removal and Installation
1. NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation
(PMI) in Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming
and Relearning
2. Raise the middle seat completely.
3. Remove the 2 pushpins and the top tray.
4. Position the cupholder aside.
1. Release the tabs.
2. Move the cupholder as far forward as possible.
3. Move the front of the cupholder as far to the driver side of the vehicle as possible.