F 150 4WD V8-4.6L VIN 8 (2010)
-
For example, if the dip switch settings were switch 1 (Right), switch 2 (Right), switch 3 (Left), switch 4 (Middle) etc., press and release the
right Lear Car2U(R) System button, then the right button, then the left button, then the middle button, etc.
5. After inputting the dip switch settings, press and release (at the same time) all 3 Lear Car2U(R) System buttons. The 3 red indicator lights are
turned on continuously.
6. Press and hold the Lear Car2U(R) System button chosen to control the garage door.
7. Once the garage door starts to move, within one second, release the button. During this time, the selected button indicator light blinks slowly. Do
not release the button until the garage door moves, which may take anywhere from 5-55 seconds, depending on the make/model of the garage door
opener.
8. The 3 red indicator lights begin to blink rapidly until programming is complete. If the garage door opener does not operate, repeat Steps 1-7.
-
For technical assistance, refer to the Owner's Literature. If necessary, contact the Lear Car2U(R) Customer Service Center at 866-572-2728, or
the customer support website at www.learcar2u.com.
9. After successful programming, the Lear Car2U(R) System operates the garage door opener using the button that was programmed. The red
indicator light behind the programmed button turns on to confirm the Lear Car2U(R) System is responding (and is programmed) to the button
command.
Erasing the Lear Car2U(R) System Buttons (Fixed Code)
1. To erase the fixed code programming from the Lear Car2U(R) System, turn the ignition key to the ON position, firmly press and hold the 2 outside
Lear Car2U(R) System buttons at the same time for approximately 20 seconds until the 3 red indicator lights begin to blink rapidly.
2. When the 3 red indicator lights begin to blink, release the buttons. The codes for all of the 3 buttons are erased.
