F 150 4WD V8-4.6L VIN 8 (2010)
Yes
INSTALL a new SJB. REFER to Smart Junction Box (SJB) See: Power and Ground Distribution/Power Distribution Module/Service and Repair. TEST
the system for normal operation.
No
The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.
-------------------------------------------------
Pinpoint Test G: DTC B1317
Smart Junction Box (SJB)
Pinpoint Tests
Pinpoint Test G: DTC B1317
Refer to Wiring Diagram Set 13, Power Distribution/SJB for schematic and connector information. See: Diagrams/Electrical Diagrams/Diagrams By
Number
Normal Operation
The Smart Junction Box (SJB) monitors the voltage from the battery to determine if it goes above or below specific thresholds and sets DTC B1317 in
continuous memory if the SJB detects high battery voltage above 15 volts on circuit SDC04.
-
DTC B1317 (Battery Voltage High) - a continuous memory DTC that sets when the SJB detects battery voltage above 15 volts on circuit SDC04.
This pinpoint test is intended to diagnose the following:
-
Charging system concern
-
SJB
PINPOINT TEST G: DTC B1317
NOTE: DTC B1317 may be stored in the module memory due to previous battery charging or vehicle jump starting events.
-------------------------------------------------
G1 CHECK FOR DTC B1317, B1676 OR P0563 SET IN OTHER MODULES
-
Ignition ON.
-
Enter the following diagnostic mode on the scan tool: (All Modules) Self-Test .
-
Retrieve the continuous memory DTCs from all modules.
-
Is DTC B1317, B1676 or P0563 (PCM) set in more than one module?
Yes
REFER to Charging System to diagnose an overcharging condition.
No
GO to G2.
-------------------------------------------------
G2 CHECK THE BATTERY VOLTAGE