F 150 4WD V8-4.6L VIN 8 (2010)
Sunroof / Moonroof Motor: Service and Repair
Roof Opening Panel Motor
Roof Opening Panel Motor
Removal and Installation
NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the
roof opening panel motor has been removed from the roof opening panel assembly, a new roof opening panel motor has been installed or when a new
roof opening panel frame has been installed. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.
1. Lower the rear of the headliner. For additional information, refer to Headliner.
-
For SuperCab vehicles, remove the B-pillar trim panels.
-
For SuperCrew vehicles, remove the C-pillar trim panels.
-
If equipped, remove the 3 headliner pin-type retainers.
-
If equipped, remove the 2 headliner garment hooks.
2. Disconnect the roof opening panel motor electrical connector.
3. Remove the 3 roof opening panel motor screws.
-
To install, tighten to 4 Nm (35 lb-in).
4. Remove the roof opening panel motor.
5. To install, reverse the removal procedure.
-
Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.