F 150 4WD V8-4.6L VIN 8 (2010)
-
Disconnect and detach the backrest heater mat electrical connector.
-
For 60 percent backrest, remove the heated seat module and bracket.
-
Disconnect the 2 heated seat module electrical connectors.
-
Remove the 2 screws, heated seat module and bracket.
-
To install, tighten to 14 Nm (124 lb-in).
-
Release the pin-type retainers and remove the wire harness.
-
Note the wire harness routing for correct installation.
5. Remove the hog rings and foam pad from the backrest frame.
6. To assemble, reverse the disassembly procedure.
Seat Backrest - Rear, SuperCab
Seat Backrest - Rear, SuperCab
Disassembly and Assembly
NOTE: For parts identification and location, refer to Seat - Exploded View, Rear, SuperCab See: Service and Repair/Rear Seats/Seat - Exploded View,
Rear, SuperCab.
1. Remove the seat backrest cover. For additional information, refer to Seat Backrest Cover - Rear, SuperCab See: Seat Cover/Service and
Repair/Rear Seats/Seat Backrest Cover - Rear, SuperCab.
2. Push the release tabs and remove the 3 backrest plastic lock clips (one shown).
3. To assemble, reverse the disassembly procedure.