F 150 4WD V8-4.6L VIN 8 (2010)
Seat Heater: Service and Repair
Seat Backrest Thermo-Electric Device
Seat Backrest Thermo-Electric Device
Removal and Installation
NOTE: For parts identification and location, refer to Seat - Exploded View, Front See: Service and Repair/Front Seats/Seat - Exploded View, Front.
1. Position the seat backrest fully forward.
2. Release the backrest cover J-clip and unzip the 2 zippers.
3. Disconnect the Thermo-Electric Device (TED) electrical connector.
4. Detach the pin-type retainer attaching the TED duct to the backrest frame.
5. Un-hook the TED from the backrest support wire and remove.
-
If equipped with power lumbar, note cable routing for correct installation.
6. To install, reverse the removal procedure.