F 150 4WD V8-4.6L VIN 8 (2010)
Install the heater mat to the foam pad.
-
Align the heater mat square to the seat with the wiring toward the rear edge and tuck the narrow areas into the valley of the foam pad.
-
Align the windows of the heater mat over the listing wire in the foam pad to allow for hog ring installation when the cushion cover is installed.
-
Firmly apply the heater mat to the foam pad and rub to seal the adhesive.
3. Route the wire harness through the hole in the foam pad and connect the electrical connector.
4. Install the seat cushion cover. For additional information, refer to Seat Cushion Cover - Front See: Seat Cover/Service and Repair/Front
Seats/Seat Cushion Cover - Front.