F 150 4WD V8-4.6L VIN 8 (2010)
Removal and Installation
1. If equipped, remove the bed liner.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
3. Remove the rear bumper. For additional information, refer to Bumper.
4. Remove the fuel filler pipe. For additional information, refer to Fuel Delivery and Air Induction.
5. Remove the wiring harness ground bolt located on the frame cross member, just above the spare tire.
-
To install, tighten to 10 Nm (89 lb-in).