F 150 4WD V8-4.6L VIN 8 (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front
Removal and Installation
1. Remove the brake disc.
2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
Disconnect the wheel speed sensor electrical connector.
3. Detach the 2 wheel speed sensor harness pushpin retainers.
4. Detach the wheel speed sensor harness retainer from the brake hose.
5. Remove the wheel speed sensor harness retainer bolt.
-
To install, tighten to 12 Nm (106 lb-in).
6. Remove the bolt and the wheel speed sensor.
-
To install, tighten the bolt to 17 Nm (150 lb-in).
7. To install, reverse the removal procedure.
