F 150 4WD V8-4.6L VIN 8 (2010)
Brake Caliper: Removal and Replacement
Brake Caliper
Brake Caliper
Removal
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
2. Remove the brake caliper flow bolt and discard the 2 copper washers.
3. Remove the 2 brake caliper guide pin bolts and the brake caliper.
Installation
1. Using 2 new copper washers, position the brake flexible hose on the brake caliper and install the brake caliper flow bolt.
-
Tighten to 40 Nm (30 lb-ft).
2. NOTE: Tighten the lower caliper guide pin bolt first.
Position the brake caliper on the brake caliper anchor plate and install the 2 guide pin bolts.
-
Tighten to 37 Nm (27 lb-ft).
3. Bleed the brake caliper.
4. Install the wheel and tire. For additional information, refer to Wheels and Tires.
Disc Brake System - Exploded View
Disc Brake System - Exploded View
NOTE: Rear Wheel Drive (RWD) shown, Four-Wheel Drive (4WD) similar.