F 150 4WD V8-4.6L VIN 8 (2010)
Parking Brake Control: Service and Repair
Parking Brake Control
Parking Brake Control
Removal and Installation
1. Remove the LH cowl side trim panel.
2. Release the tension on the parking brake cable. For additional information, refer to Parking Brake Cable Tension Release See: Parking Brake
Cable/Service and Repair/Procedures.
3. Remove the parking brake release handle bolt and pull the handle assembly down to prevent breaking off the locator tabs.
4. Disconnect the parking brake release handle cable from the parking brake control.
5. Disconnect the parking brake switch electrical connector.
6. Remove the 3 bolts from the parking brake control.
-
To install, tighten to 20 Nm (177 lb-in).
7. Position the cable conduit grommet up through the floor.
-
Release the cable from the parking brake control.
8. Remove the parking brake control from the vehicle.
9. To install, reverse the removal procedure.
-
Inspect the parking brake system for correct operation.