F 150 4WD V8-4.6L VIN 8 (2010)
35. Disconnect the power steering cooler-to-power steering fluid reservoir hose from the power steering fluid reservoir.
36. Remove the 6 cooling module bolts.
37. Remove the cooling module.
Installation
1. Position the cooling module into the vehicle.
2. Install the 6 cooling module bolts.
-
Tighten to 30 Nm (22 lb-ft).
3. Connect the power steering cooler-to-power steering fluid reservoir hose at the power steering reservoir.
4. Connect the transmission cooler tubes to the cooling module.
5. Install the transmission cooler tube latch assemblies.
6. Install the 2 LH air deflector-to-frame rail pushpins.
7. Install the 2 RH air deflector-to-frame rail pushpins.