F 150 4WD V8-4.6L VIN 8 (2010)
a
The pin bore and crank bearing bore must be parallel and in the same vertical plane within the specified total difference when measured at the ends
of a 203 mm bar, 105.5 mm on each side of rod centerline.
ROD BEARING CAP
Tighten the 16 bolts in 3 stages, in the sequence shown.
Stage 1: Tighten to.........................................................................................................................................................................................23 Nm (17 lb-ft).
Stage 2: Tighten to.........................................................................................................................................................................................43 Nm (32 lb-ft).
Stage 3: Tighten an additional...............................................................................................................................................................................105 degrees.