F 150 4WD V8-4.6L VIN 8 (2010)
8. Rotate the accessory drive belt tensioner clockwise and detach the accessory drive belt from the generator pulley.
9. Detach the radio interference capacitor wiring harness retainer from the generator wiring harness.
10. Remove the 2 generator bracket-to-coolant crossover bolts.
11. Loosen the 2 generator nuts, and position the generator, bracket and wiring harness aside as an assembly.
12. Remove the 10 intake manifold bolts.
13. Release the clamp and disconnect the upper radiator hose from the thermostat housing.
14. Release the clamp and disconnect the heater hose from the coolant crossover manifold.
15. Remove the 2 bolts and the coolant crossover manifold and discard the 2 gaskets.
16. Position the intake manifold forward and detach the 3 wiring harness retainers from the rear of the intake manifold and detach the wiring harness
retainer from the brake booster hose.
17. Disconnect the Charge Motion Control Valve (CMCV) electrical connector.
