F 150 4WD V8-4.6L VIN 8 (2010)
1. Install the LH and RH camshafts.
-
Lubricate the camshaft and camshaft journals with clean engine oil prior to installation.
2. NOTE: LH shown, RH similar.
Install the LH and RH camshaft bearing caps in their original locations.
-
Lubricate the camshaft bearing caps with clean engine oil.
-
Position the front camshaft bearing cap.
-
Position the remaining camshaft bearing caps.
-
Install the bolts loosely.
-
Tighten to 10 Nm (89 lb-in) in the sequence shown.
3. NOTICE: Damage to the camshaft phaser sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
NOTE: LH shown, RH similar.
Install the camshaft phaser sprockets and new camshaft phaser bolts finger-tight.
4. NOTICE: Damage to the camshaft phaser sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
NOTICE: Only use hand tools to remove the camshaft phaser sprocket assembly or damage may occur to the camshaft or camshaft
phaser unit.
NOTE: LH shown, RH similar.
Using the Cam Phaser Locking Tool, tighten the LH and RH camshaft phaser sprocket bolts in 2 stages.
-
Stage 1: Tighten to 40 Nm (30 lb-ft).
-
Stage 2: Tighten an additional 90 degrees.