F 150 4WD V8-4.6L VIN 8 (2010)
8. Remove the starter wiring harness bracket bolt at the starter.
9. Remove the nut and position the transmission cooler tube support bracket and the starter wiring harness support bracket aside.
10. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
11. Remove the nut and position aside the Power Steering Pressure (PSP) hose support bracket.
12. Remove the crankshaft pulley bolt and washer.
-
Discard the crankshaft pulley bolt.
13. Using the 3 Jaw Puller, remove the crankshaft pulley.
14. Using the Crankshaft Front Seal Remover, remove and discard the crankshaft front seal.