F 150 4WD V8-4.6L VIN 8 (2010)
4. Loosely install the 4 bolts, then tighten the bolts in 2 stages, in the sequence shown.
-
Stage 1: Tighten to 20 Nm (177 lb-in).
-
Stage 2: Tighten an additional 60 degrees.
5. Connect the CKP sensor electrical connector.
6. Position the starter wiring harness support bracket and the transmission cooler tube support bracket and tighten the nut.
-
Tighten to 10 Nm (89 lb-in).
7. Install the starter wiring harness bracket bolt at the starter.
-
Tighten to 10 Nm (89 lb-in).
8. Lubricate the engine front cover and the new crankshaft seal inner lip with clean engine oil.