F 150 4WD V8-4.6L VIN 8 (2010)
Refrigerant: Service and Repair
Refrigerant System Filtering Following Air Conditioning (A/C) Compressor Installation
Refrigerant System Filtering Following Air Conditioning (A/C) Compressor Installation
NOTICE: On vehicles being serviced for an internal compressor or desiccant failure, a new Thermostatic Expansion Valve (TXV) and any
hoses containing mufflers must be installed prior to filtering the Air Conditioning (A/C) system. Internal plumbing of these devices makes it
impossible to correctly remove any foreign material/debris. These components are typically discarded after A/C system contamination. Hoses
without mufflers can normally be reused unless they are clogged with foreign material. The F8VZ-19E773-AB filter is intended for use on one
vehicle only.
1. Remove the condenser core.
2. Remove the plastic receiver/drier cap.
3. Remove the receiver/drier plug.
1. Push the receiver/drier plug upwards and remove the snap ring.
2. Install an M5 bolt in the center of the receiver/drier plug and remove the plug.
4. Using a suitable tool, grasp the receiver/drier cartridge grab handle and remove the receiver/drier cartridge.
5. NOTE: Do not install a new receiver/drier cartridge at this time.