F 150 4WD V8-4.6L VIN 8 (2010)
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be
ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the fuel tank. For additional information, refer to Fuel Tank See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Tank/Service and Repair/Removal and Replacement/Fuel Tank.
3. Using soapy water, clean a minimum of 76 mm (3 in) surface area around the Fuel Pump (FP) module.
4. If equipped, remove the 4 fuel pump module cover nuts and remove the fuel pump module cover.
-
To install, tighten to 9 Nm (80 lb-in).
5. Disconnect the fuel supply tube and Fuel Tank Pressure (FTP) sensor and vapor tube assembly quick connect couplings at the FP module.
6. Using the Fuel Tank Sending Unit Wrench, remove the FP module locking ring.
