F 150 4WD V8-4.6L VIN 8 (2010)
Tail Lamp: Service and Repair
Rear Lamp Assembly
NOTE: Styleside lamp shown, flareside similar.
Removal and Installation
1. Remove the 2 rear lamp assembly bolts.
-
To install, tighten to 5 Nm (44 lb-in).
2. Firmly pull the rear lamp assembly rearward to disengage the metal studs from the grommets on the outboard side of the sheet metal.
-
Disconnect the electrical connectors.
3. If necessary, rotate the bulb holder counterclockwise approximately one-eighth turn and remove it.
-
Separate the bulb from the bulb holder.
4. To install, reverse the removal procedure.