F 150 4WD V8-4.6L VIN 8 (2010)
7. Using the scan tool, verify that the TFT is between 80°C-85°C (176°F-185°F). The transmission fluid level must be at the upper level of the
crosshatch mark.
8. NOTE: If the transmission fluid is over full, follow the steps for Removing Transmission Fluid in this procedure.
Install the transmission fluid fill plug.
-
Tighten to 35 Nm (26 lb-ft).
Removing Transmission Fluid
NOTE: To get an accurate transmission fluid level reading the engine should be idling (600-750 rpm) in PARK.
1. If the transmission is overfilled, transmission fluid must be removed to the correct level. Use the Transporter Fluid Evacuator/Injector and the
Vacuum Pump Kit to extract any excessive transmission fluid.
2. Using the scan tool, verify that the TFT is between 80°C-85°C (176°F-185°F). The transmission fluid level must be at the upper level of the
crosshatch mark. Reinstall the transmission fluid level indicator only back into the transmission fluid fill plug hole to check the transmission fluid
level. Repeat this until a consistent reading is established.
3. Install the transmission fluid fill plug.
-
Tighten to 35 Nm (26 lb-ft).
