F 150 4WD V8-4.6L VIN 8 (2010)
Removal and Installation
1. Remove the instrument cluster finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
2. Remove the 4 screws and the in-dash computer.
-
Disconnect the electrical connectors.
3. NOTICE: Make sure the modem-antenna cable is routed to allow enough clearance for the in-dash computer. Failure to follow this
instruction may result in damage to the modem-antenna cable.
To install, reverse the removal procedure.
Telematics Module
Telematics Module
Removal
1. Turn the ignition to OFF.
2. Remove the instrument panel upper bin.
1. Remove the rubber mat.
2. Remove the 2 screws.
3. Remove the instrument panel upper bin.
3. Disconnect the telematics module electrical connector.
4. Remove the 2 screws and the telematics module.
5. To install, reverse the removal procedure.