F 150 4WD V8-4.6L VIN 8 (2010)
12. Position the stabilizer bar, install the 2 stabilizer bar brackets and the 4 new stabilizer bar bracket nuts.
-
Tighten the nuts to 55 Nm (41 lb-ft).
13. NOTICE: Do not hold the stabilizer link boot with any tool as damage to the boot will occur.
NOTE: Use the hex-holding feature to prevent the stud from turning while installing the nuts.
Install the 2 new stabilizer bar link lower nuts.
-
Tighten the nuts to 80 Nm (59 lb-ft).
14. Check and, if necessary, adjust the front toe. For additional information, refer to Toe Adjustment - Front See: Toe Adjustment - Front.