F 150 4WD V8-4.6L VIN 8 (2010)
Power Steering Fluid Reservoir: Service and Repair
Power Steering Fluid Reservoir
Removal and Installation
1. NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign materials or failure of the
power steering components may result.
Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
2. Detach the wiring harness retainer from the stud bolt and position the wiring harness aside.
3. Release the clamp and disconnect the power steering pump supply hose.
4. Release the clamp and disconnect the return hose.
5. Remove the stud bolt and the power steering fluid reservoir.
-
To install, tighten to 8 Nm (71 lb-in).
6. To install, reverse the removal procedure.
7. Fill the power steering system.