F 150 4WD V8-4.6L VIN 8 (2010)
1. Remove the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley See: Power Steering Pump/Service and
Repair/Power Steering Pump Pulley.
2. Remove the 2 bolts and the oil drip shield.
-
To install, tighten to 7 Nm (62 lb-in).
3. Disconnect the power steering pressure line-to-power steering pump fitting.
-
To install, tighten to 75 Nm (55 lb-ft).
4. Remove the power steering pressure line bracket-to-crossmember bolt.
-
To install, tighten to 7 Nm (62 lb-in).
5. Remove the power steering pressure line bracket-to-engine nut.
-
To install, tighten the 5.4L to 40 Nm (30 lb-ft).
-
To install, tighten the 4.6L to 12 Nm (106 lb-in).
6. Remove the power steering line clamp bolt, rotate the clamp plate and disconnect the power steering pressure line.
-
To install, tighten to 23 Nm (17 lb-ft).
7. To install, reverse the removal procedure.
8. Fill the power steering system.