F 150 4WD V8-4.6L VIN 8 (2010)
3. Position the selector lever boot up the selector lever.
4. Turn the steering wheel one-half turn to access the slots on each side of the steering column shroud.
5. Insert a suitable tool into each slot to unsnap and remove the steering column upper shroud. Rotate the upper shroud on its hinges and pull
rearward to remove the shroud from its hinges.
6. Disconnect the electrical connector and remove the screw that retains the harness clip to the steering column.
7. Remove the selector lever bolt.
-
To install, tighten to 18 Nm (159 lb-in).